[1] Turn on the controller buttons in order of power and heater. (Red button - Power on, Green button - Controller on)
[2] To start setting the target temperature, press the ‘SET’ button on the heat controller.
[3] Press the arrow(up/down) button to set the target temperature. (hold the button if you want to change it faster)
[4] If you set the number to the target temperature value, press the ‘SET’ button to confirm the target temperature.
[5] Check if the temperature is set properly on the led panel. (PV - Process value , SV - Set value)
💡 The temperature difference of about 30℃ between PV and SV is normal.
💡 Most commonly used temperature for plastic injection is 200℃. However , it can be adjusted according to several different factors.